Supported tags and respective
Where to file issues:
the Kaazing Docker Maintainers
Supported Docker versions:
the latest release (down to 1.6 on a best-effort basis)
What is the KAAZING Gateway?
The Kaazing Gateway is a network gateway created to provide a single access point for real-time web based protocols that supports load balancing, clustering, and security management. It is designed to provide scalable and secure bidirectional event-based communication over the web; on every platform, browser, and device.
How to use this image
Up and Running
By default the gateway runs a WebSocket echo service similar to websocket.org.
You must give your gateway container a hostname. To do this, use the
docker run -h somehostname option, along with the -e option to define an environment variable, GATEWAY_OPTS, to pass this hostname to the gateway configuration (your hostname may vary):
$ docker run --name some-kaazing-gateway -h somehostname -e GATEWAY_OPTS="-Dgateway.hostname=somehostname -Xmx512m -Djava.security.egd=file:/dev/urandom" -d -p 8000:8000 arm64v8/kaazing-gateway
Note: the additional GATEWAY_OPTS options,
-Xmx512m -Djava.security.egd=file:/dev/urandom, are added in order to preserve these values from the original Dockerfile for the gateway. The
-Xmx512m value specifies a minimum Java heap size of 512 MB, and
-Djava.security.egd=file:/dev/urandom is to facilitate faster startup on VMs. See the
Dockerfile link referenced above for details.
You should then be able to connect to ws://somehostname:8000 from the WebSocket echo test.
Note: all of the above assumes that
somehostname is resolvable from your browser. You may need to add an etc/hosts entry for
somehostname on your
To launch a container with a specific configuration you can do the following:
$ docker run --name some-kaazing-gateway -h somehostname -e GATEWAY_OPTS="-Dgateway.hostname=somehostname -Xmx512m -Djava.security.egd=file:/dev/urandom" -v /some/gateway-config.xml:/kaazing-gateway/conf/gateway-config.xml:ro -d arm64v8/kaazing-gateway
For information on the syntax of the Kaazing Gateway configuration files, see the official documentation (specifically the For Administrators section).
If you wish to adapt the default Gateway configuration file, you can use a command such as the following to copy the file from a running Kaazing Gateway container:
$ docker cp some-kaazing:/kaazing-gateway/conf/gateway-config-minimal.xml /some/gateway-config.xml
As above, this can also be accomplished more cleanly using a simple
FROM arm64v8/kaazing-gateway COPY gateway-config.xml conf/gateway-config.xml
Then, build with
docker build -t some-custom-kaazing-gateway . and run:
$ docker run --name some-kaazing-gateway -d some-custom-kaazing-gateway
For more information on the GATEWAY_OPTS environment variable, see Configure Kaazing Gateway Using the GATEWAY_OPTS Environment Variable.
View license information for the software contained in this image.
As with all Docker images, these likely also contain other software which may be under other licenses (such as Bash, etc from the base distribution, along with any direct or indirect dependencies of the primary software being contained).
Some additional license information which was able to be auto-detected might be found in the
As for any pre-built image usage, it is the image user's responsibility to ensure that any use of this image complies with any relevant licenses for all software contained within.