lacsap/dosbox repository overview

⁠dosbox in a container

This Dockerfile will create an image from which you can run a dosbox container. The dosbox config file is located in the /root/.dosbox/ volume, and the /dosbox volume will be where you write your data. If you write anywhere but in those two directory (/dosbox and /root/.dosbox/) you will lose that data once you destroy the container.

⁠How to use it

You can start a dosbox container with those 2 commands:

xhost +

docker run -ti --rm -e DISPLAY=$DISPLAY -v /tmp/.X11-unix:/tmp/.X11-unix -v /path/on/your/system/data:/dosbox -v /path/on/your/system/config:/root/.dosbox lacsap/dosbox

• replace /path/on/your/system/data and /path/on/your/system/config with any directory on your system where you wish to store the data and config of dosbox.
• after dosbox is launched, type MOUNT C /dosbox in the prompt to mount your data volume in dosbox. (you can automate this by putting the mount command at the end of dosbox's config file)

⁠Notes

• When you are done using dosbox you should probably run xhost - to re-enable the access control to the X server.
• This will launch dosbox in a GUI so you can't run this without an X server.