Public | Automated Build

Last pushed: 2 years ago
Short Description
Short description is empty for this repo.
Full Description

This is a Dockerfile setup for PlexConnect -

To run:

docker run -d --host="name" --name="plexconnect" -v /path/to/plexconnect/ssl:/opt/plexconnect/assets/certificates:rw -v /etc/localtime:/etc/localtime:ro -p 80:80 pducharme/plexconnect


PlexConnect must listen on port 80 and port 443. So you must move the unRAID management interface to a new port.

  1. Edit /boot/config/go
  2. Replace: /usr/local/sbin/emhttp &
  3. With: /usr/local/sbin/emhttp -p XX & (where XX equals the port)
  4. Shutdown your array
  5. Reboot unRAID


Put your SSL certificates in /path/to/plexconnect/ssl if they do not exist the docker will generate them for you.

Docker Pull Command
Source Repository

Comments (2)
2 years ago

You need to map to a folder on the Host. In your case, the QNAP. But i'm pretty sure that this Docker won't run on a QNAP because it's a lot different from Unraid...

2 years ago

Hi. Forgive my ignorance, but I am trying to set this up on my QNAP NAS but I can't figure out how to get access to the settings.cfg and the folders to add my certs. Do you think you could help me? I imagine its quite different to unRAID...