follyengine/terraform repository overview

⁠terraform - RPi configure for folly controller

Use Terraform to setup the RPi controller for FollyEngine

will result in:

• folly user setup
• Docker installed and running
• Wireguard installed and configured
• node-red installed
• Unifi controller configured with initial Folly WiFi
• the 7inch screen working
• secrets, passords etc from Lastpass

⁠How to use

1. Pre-req's
   • https://github.com/nrkno/terraform-provider-lastpass⁠
   • sudo apt-get install lastpass-cli - oh, actually, this needs to be inside the terraform image bbiab
2. Flash the SDCard with XXX
   • Do we need to enable ssh?
   • starting with Raspbian Buster Lite - 2020-02-13
   • fdisk -l
   • dd if=2020-02-13-raspbian-buster-lite.img of=/dev/mmcblk0 bs=4096
   • sync
   • remove sdcard, and put back in to re-init partition table cache (may not be needed anymore?)
   • mount /dev/mmcblk0p1 /mnt
   • touch /mnt/ssh
   • umount /mnt
   • sync
   • remove sdcard, and put in pi & boot...
   • find ip address, then ssh pi@<ip address>, default password ~ raspberry
3. Boot, and get IP Address
4. make init
5. make plan
6. make apply

⁠Curiosities

Would it be possible to PXE boot a new RPi (or network boot..), then have that auto-trigger Terraform...