Build C/C++ firmwares for the ESP8266
10K+
Source: https://github.com/Jack12816/buildbox-esp8266
This is a Docker container for building C/C++ firmwares for the ESP8266. The ESP8266 (Xtensa RISC) processor is supported.
To build a project with the Xtensa toolchain run the container like this:
$ docker run --rm -v `pwd`:/share -w /share \
jack12816/buildbox-esp8266 make build
The command make build is just an example and must be replaced with your own build command.
The Xtensa toolchain includes these binaries:
xtensa-lx106-elf-c++ xtensa-lx106-elf-c++filt xtensa-lx106-elf-cc
xtensa-lx106-elf-cpp xtensa-lx106-elf-ct-ng.config xtensa-lx106-elf-elfedit
xtensa-lx106-elf-g++ xtensa-lx106-elf-gcc xtensa-lx106-elf-gcc-4.8.2
xtensa-lx106-elf-gcc-ar xtensa-lx106-elf-gcc-nm xtensa-lx106-elf-gcc-ranlib
xtensa-lx106-elf-gcov xtensa-lx106-elf-gdb xtensa-lx106-elf-gprof
xtensa-lx106-elf-ld xtensa-lx106-elf-ld.bfd xtensa-lx106-elf-nm
xtensa-lx106-elf-objcopy xtensa-lx106-elf-objdump xtensa-lx106-elf-ranlib
xtensa-lx106-elf-readelf xtensa-lx106-elf-size xtensa-lx106-elf-strings
xtensa-lx106-elf-strip```
## Image Building
Just clone this git repository and run `make`. It will show up a complete
documentation of all available commands. The default workflow is the following:
build -> release -> publish
If you expecting any issues while testing the newly built image after release
run `make clean` and start over. All commands are idempotent and can be
executed multiple times with the same result. (Just keep in mind that the
release process will always increase the version number)
Content type
Image
Digest
Size
348.3 MB
Last updated
over 9 years ago
docker pull jack12816/buildbox-esp8266